Epson RC90 Series - Fan Filter

Maintenance 8. Maintenance Parts Replacement Procedures
RC90 Series Maintenance Rev.1 39
8.1 Fan Filter
Inspect the fan filter periodically and clean it when needed. The temperature inside the
Controller may get too high and the Controller may not operate properly if the filter is not
kept clean.
Fan Filter
Remov
al
(1)
Turn OFF the Controller.
(2)
Remove two screws of the fan filter.
(3)
Remove
the fan filter cover.
(4)
Detach
the fan filter.
Vacuum off the dust when cleaning the filter.
Fan Filter
Installation
(1)
Set the fan filter to the fan
filter cover.
(2)
Mount
the fan filter cover with two screws.
(3)
Connect the power plug
. Turn ON the Controller and make sure that the
Controller
starts properly without any vibration or abnormal noise.