Epson RC90 Series - Mdb

Maintenance 8. Maintenance Parts Replacement Procedures
44 RC90 Series Maintenance Rev.1
8.5 MDB
MDB
Removal
(1)
Turn OFF the Controller.
(2)
Disconnect the power
plug.
(3)
Remove
the Top Panel.
For LS3-B, LS6-B: Mounting screws ×10
For LS10-B, LS20-B, LS6-B602S-V1: Mounting screws ×6
(4)
Remove the output cable of each axis of
the MDB
.
(5)
Remove
the screws on the chassis side surface
(×4).
(5)
(7)
(6)
P
ull out the MDB clamp for the upright
mounting.
(7)
R
emove the screws on the chassis side surface.
(
×2)
(8)
Remove the
MDB clamp.
(Mounting screw
×2)
(9)
Pull out the
MDB
in the direction shown in the
picture.