Epson RC90 Series - CF (Compact Flash)

Maintenance 8. Maintenance Parts Replacement Procedures
RC90 Series Maintenance Rev.1 43
8.4 CF (Compact Flash)
CF Removal
(1)
Turn OFF the Controller and unplug the power connector.
(2)
Remove
the Top Panel.
For LS3-B, LS6-B: Mounting screws ×10
For LS10-B, LS20-B, LS6-B602S-V1: Mounting screws ×6
(3)
Remove the CF mounting screw (
×1).
(4)
Pull the CF toward the direction of the arrow in
the picture.
CF
Installation (1)
Insert a new CF toward the opposite direction of the arrow in the picture above.
(2)
Tighten the CF mounting screw (
×1).
(3)
Mount the Top Panel.
For LS3-B, LS6-B: Mounting screws ×10
For LS10-B, LS20-B, LS6-B602S-V1: Mounting screws ×6
(4)
Connect the power plug. Turn ON the Controller and make sure
that the
Controller starts
properly without any vibration or abnormal noise.