Epson RC90 Series - Page 57

Maintenance 8. Maintenance Parts Replacement Procedures
RC90 Series Maintenance Rev.1 45
MDB
Installation
(1)
Insert the
MDB in the direction shown in the picture.
(2)
Mount the
MDB clamp.
(Mounting screw
×2)
(3)
Tighten
the screws on the chassis side surface.
(
×2).
(5)
(3)
(4)
Mount the
MDB clamp for the upright mounting.
(5)
Tighten
the screws on the chassis side surface
(
×4).
(6)
Mount the output cable of each axis of
the MDB.
When mounting the output cables, make sure that the
number on the
MDB clamp and the connector are the
same.
(7)
Mount the Top Panel.
For LS3-B, LS6-B: Mounting screws ×10
For LS10-B, LS20-B, LS6-B602S-V1: Mounting screws ×6
(8)
Connect the power plug
. Turn ON the Controller and make sure that the
Controller starts
properly without any vibration or abnormal noise.

NOTE