R Ink tank
Holds ink used for printing.
S Heat shield
Prevents the temperature of the ink in the ink tank from rising when using a commercially available heater. Make
sure you clean the heat shield if any ink has adhered to it.
U “Cleaning the Heat Shield” on page 66
T Slider
U “Slider” on page 12
U Lock lever
Raise the lock lever to unlock the slider for removal when replacing the chip unit. Always lower the lock lever into
the locked position after inserting the slider.
V Chip unit check lamp
This lamp turns on when a message related to the chip unit is displayed.
On : Check the contents of the error on the control panel’s screen and deal with the error.
Off : No error.
W Stirring stick
This is only for the High Density Black ink tank. Stir the ink in the ink tank once a week.
X AC inlet #1/AC inlet #2
Connects the power cable. Be sure to connect both cables.
Y LAN port
U “LAN port” on page 12
Z USB port
Connects the USB cable.
a Maintenance cover (right)
Open this cover to perform maintenance around the print head. Normally closed when using the printer.
U “Cleaning” on page 59
b Media loading lever
After loading media, lower the media loading lever to keep the media in place. Raise the lever to release the media
prior to removal.
c Alert lamp
This lamp lights or flashes when an error occurs.
On/
Flashing
: An error occurred. The type of error is indicated by how the lamp lights or flashes. Check the contents
of the error on the control panel’s screen.
Off : No error.
d Control panel
U “Control panel” on page 16
SC-F9200 Series User's Guide
Introduction
10
To Next Page
Loading...
Need help?
General