Epson SC-F9200 series

Pressing this button displays the Heating & Drying
menu, where you can adjust the Heater
Temperature. This menu can be adjusted during
printing.
U “The Media Setup Menu” on page 92
K # button (maintenance button)
Pressing this button displays the Maintenance
menu, which contains such items as Nozzle Check,
Cleaning, Head Maintenance, and Waste Ink
Counter. This button is disabled during printing.
U “The Maintenance Menu” on page 98
L W button (pause/cancel button)
❏ The printer enters pause status if this is pressed while
printing. To release the pause status, press the W
button again, or select Pause Cancel on the screen
and then press the Z button. To cancel print jobs
being processed, select Job Cancel on the screen and
then press the Z button.
❏ Pressing this button when menus are displayed closes
the menus and returns the printer to ready status.
M
button (media feed button)
❏ When the printer is in the ready state, you can feed the
media to the cut position by pressing this button and
then Z.
U “Cutting Media” on page 33
❏ When printing is in progress, you can use this button
to adjust media feed.
U “Feed Adjustment” on page 49
Understanding the Display
A Messages
Displays the printer’s status, operation, and error
messages.
U “When a Message is Displayed” on page 101
B Heater temperature
This display shows the temperature settings for the
after heater. The thermometer icons give a rough
indication of the current temperatures of the heaters.
: The heater has reached the selected
temperature.
: The heater has not reached the selected
temperature.
C Feed adjustment information during printing
Displayed when an adjustment value has been
entered during printing.
D Media info
❏ From left to right, this display shows the selected
media, platen gap, media width, and media
remaining.
❏ If a media setting bank number registered with this
printer is selected as the print media, the number
(from 1 to 30) will be displayed. When RIP Settings is
selected, 0 will be displayed.
❏ The selected platen gap is shown as follows.
:1.5
:2.0
:2.5
❏ The media remaining is not displayed if Off is selected
for Remaining Setup in the Media Remaining menu.
U “The Media Setup Menu” on page 92
SC-F9200 Series User's Guide
Introduction
17