Epson SC-F9200 series User Manual

O
Insert the media approximately 30 cm into the
opening, then lower the media loading lever.
P
Confirm that the left edge of the media passes
within the square of the label on the loading
guide.
c
Important:
Perform Steps 16 to 5 in reverse order and
repeat the loading process if the left edge of the
media is not within the black square of the
label. Do not attempt to reposition the roll
holders while they are inserted in the media.
Q
Go to the front of the printer and open the front
cover.
R
Hold the center of the media and raise the media
loading lever.
S
Pull the media straight forward to the leading
edge of the after heater.
T
Close the front cover.
U
Rewind the leading edge of the media to the front
cover.
For Printable Side Out media press the u button,
and for Printable Side In media press the d to
rewind the media.
SC-F9200 Series User's Guide
Basic Operations
30

Epson SC-F9200 series Specifications

General

Brand	Epson
Model	SC-F9200 series
Category	Printer
Language	English