Epson SC-F9200 series User Manual

A to D indicates the margins on all four sides. See the following for more details.
Margin
Position
Explanation Available
Setting
Range
A Bottom
*1
This can be configured in RIP. To maintain media feeding accuracy, if the setting is less
than 5 mm the setting is switched to 5 mm.
5 mm or more
B Top
*1, *2
This can be configured in RIP. Differs by the length the media was pulled when the media is
loaded. For continuous printing, although the margins configured in RIP are added, to
maintain media feeding accuracy, if the setting is less than 5 mm the setting is switched to
5 mm.
5 mm or more
CLeft
*3, *4
The value selected for Side Margin(Left) in the printer's setup menu. The default setting is
5 mm.
3 to 25mm
DRight
*3, *4
The total of the values selected for Print Start Position and Side Margin(Right) in the
printer's setup menu. The default setting for Print Start Position is 0 mm and Side
Margin(Right) is 5 mm.
3 to 825mm
*1 The configured margin and the actual print results may differ depending on the RIP being used. Contact the RIP
manufacturer for more information.
*2
When No Margin is selected in Margin Between Pages from the printer's settings menu, you can adjust the
margin within a range of -10 to 10 mm.
*3 This may be available in the RIP depending on the RIP software being used. Contact the RIP manufacturer for
more information.
*4 Note the following points when configuring margins.
❏ Leave margins of 10 mm or more when using media holding plates. Narrower margins could result in printing over the
plates.
❏ If the total of the print data width and configured left and right margins exceeds the printable area, a portion of the data
will not be printed.
Note:
If the following points are not observed when Media Size Check is Off, printing may occur outside the left and right edges of
the media. Ink used outside the edges of the media will stain the inside of the printer.
❏ Ensure that the print data width does not exceed the loaded media width.
❏ When media is loaded to the left of the right side reference position, align the Print Start Position setting with the
position where the media set.
U “Printer Setup Menu” on page 96
SC-F9200 Series User's Guide
Basic Operations
54

Epson SC-F9200 series Specifications

General

Brand	Epson
Model	SC-F9200 series
Category	Printer
Language	English