B
Press the d/u buttons to select Heater
Temperature, and then press the Z button.
C
Choose a value.
Press the d/u buttons to set the temperature.
D
When you press the Z button, the settings for
the currently selected media are updated, and
the Heating & Drying menu is displayed.
E
When you press the y button, the menu is
closed and the status display screen is displayed.
Note:
The time needed for the heaters to reach the
specified temperatures varies with the ambient
temperature.
Correcting Banding
When you want to correct banding during printing,
perform Feed Adjustment.
Buttons that are used in the following settings
A
Press the M button during printing.
The current adjustment value is displayed.
B
Use the d/u buttons to change the current value.
If the feed amount is too small, black bands
(dark stripes) will appear; adjust the feed
amount upwards.
If, in contrast, the feed amount is too large,
white bands (pale stripes) will appear; adjust
the feed amount downwards.
C
Check the printing result. If you are not
satisfied with the results, use the d/u buttons
to change the value.
This updates the setting value of Feed
Adjustment in the currently selected media
settings.
D
Press the Z button to display the status
display screen.
Note:
If the setting is changed, the icon is displayed on
the control panel screen as shown below. To clear
this icon, carry out the following operations.
❏ Restart Feed Adjustment.
❏ Execute Restore Settings.
SC-F9300 Series User's Guide
Basic Operations
51
To Next Page
Loading...
Need help?
General