Epson SC-F9300 series - Take-Up with the Printed Side Facing out

Note:
You can confirm differences in tension by lightly
tapping both edges of the media as shown in the
illustration below.
F
Hold down the d button until the edges of the
media are taken up and wrap around the core
once or twice.
Take-up with the Printed Side
Facing Out
A
While pulling the center section of the media
straight down, affix the media to the take up
roll core with commercially available adhesive
tape.
c
Important:
Attach the media to the take-up roll core
with the media pulled tightly. If media is
attached loosely, the media may move
around during take-up.
B
Hold down the d button in the control panel to
feed enough media for a single wrap around the
take-up roll core.
SC-F9300 Series User's Guide
Basic Operations
39