Epson Stylus C82 - Housing Removal; Upper Housing Removal; Panel Housing;C486 PNL Board Removal

EPSON Stylus C82 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 27
4.2.1 Housing Removal
4.2.1.1 Upper Housing Removal
1. Remove 4 screws (C.B.P 3x10) holding the Upper Housing.
2. Open Stacker.
Figure 4-2. Upper Housing Removal 1
3. Follow the order shown in Figure 4-3 to release 5 hooks from the Lower Housing.
(Use a pair of tweezers to press hooks 1 and 2 into slots and release while pressing
in the direction of the arrow. Hooks 4 and 5 can be released by pressing them
through the slots with a pair of tweezers.)
Figure 4-3. Upper Housing Removal 2
4. While slightly lifting Upper Housing, follow the order shown below to remove (1)
1 screw (C.B.S 3x6) and (2) FFC (from C486 PNL Board). Then remove the
Upper Housing.
Figure 4-4. Upper Housing Removal 3
4.2.1.2 Panel Housing/C486 PNL Board Removal
1. Remove Upper Housing. (See Section 4.2.1.1)
2. While pressing inward the 2 hooks holding the Panel Housing, remove the Panel
Housing by pushing it in the direction of arrow A.
Figure 4-5. Panel Housing/C486 PNL Board Removal 1
Upper Housing
Stacker
Lower Housing
C.B.P 3x10 (6±1kgf.cm) x2
C.B.P 3x10 (6±1kgf.cm) x2
<Right Front
Bottom Surface>
<Left Rear Side>
Hook
<Right Rear Side>
Hook
<Left Front Bottom Surface>
Hook
<Left Side (Inner Side)>
Hook
1
2
3
4
5
Hook
FFC
<Right Front Side>
C486 PNL board
1
2
Disconnect
C.B.S 3x6 (6±1kgf.cm)
Panel Housing
Hooks
A
Upper Housing