ENERGY STAR Compliance 45
Memory Card Safety Instructions
■ Do not remove the memory card or turn off the Stylus CX while the computer and memory
card are communicating (the memory card light or the On light is flashing).
■ Use only memory cards compatible with this product.
ENERGY STAR Compliance
As an ENERGY STAR Partner, Epson has determined that this product
meets the E
NERGY STAR guidelines for energy efficiency. The EPA
ENERGY STAR office equipment program is a voluntary partnership
with the computer and office equipment industry to promote the
introduction of energy-efficient personal computers, monitors, printers,
fax machines, and copiers in an effort to reduce air pollution caused by power generation.
FCC Compliance Statement
For United States Users
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio or television reception. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause interference to
radio and television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
■ Consult the dealer or an experienced radio/TV technician for help.
WARNING
The connection of a non-shielded equipment interface cable to this equipment will invalidate the
FCC Certification of this device and may cause interference levels which exceed the limits
established by the FCC for this equipment. It is the responsibility of the user to obtain and use a
shielded equipment interface cable with this device. If this equipment has more than one interface
connector, do not leave cables connected to unused interfaces. Changes or modifications not
expressly approved by the manufacturer could void the user’s authority to operate the equipment.
4049978_b0_00.book Page 45 Thursday, July 22, 2004 3:47 PM
To Next Page
Loading...
Need help?
General