• Do not carry the product by its control panel; this may damage the product.
1. Turn off the product.
2. Lift up the scanner and check to see if the print head is in the far right position (the home position). If
not, turn on the product, wait for the print head to move, then turn the product off again.
3. Secure the ink cartridge holder to the case with tape.
Caution: Do not place tape on the white flat cable inside the product; otherwise, you may damage
your product.
4. Lower the scanner.
5. Remove all the paper from the product.
6. Unplug any connected cables.
7. Close the output tray and paper support.
167
To Next Page
Loading...
