84
❏ If the paper is curled toward the printable side, flatten it or
curl it slightly in the opposite direction.
❏ Make sure that the Paper Type setting in your LCD panel is
correct.
❏ Remove each sheet from the output tray as it is printed,
especially if you are using transparencies.
❏ If you are printing on glossy media or transparencies, place a
support sheet (or a sheet of plain paper) beneath the stack, or
load only one sheet at a time.
❏ Do not touch or allow anything to come into contact with the
printed side of transparencies or paper with a shiny finish.
After printing documents on transparencies or glossy media,
allow the ink to set for a few hours before handling them.
❏ Run the Head Cleaning utility.
& See “Cleaning the Print Head” on page 71
❏ Run the Print Head Alignment utility.
& See “Aligning the Print Head” on page 73
To Next Page
Loading...
