Epson Stylus Pro 3800 - Page 114

The Control Panel 114
EPSON Stylus Pro 3800 User’s Guide
9. Select PLATEN GAP, and then press the Menu/Right r button. Press the Paper
Feed/Down d or Ink Cover Open/Up u button to select NARROW, STANDARD, WIDE, or
WIDER. Then press the Enter button to save the selected platen gap setting.
10.Press the Back/Left l button.
11.Select THICKNESS PATTERN, and then press the Menu/Right r button. Press the
Enter button to print the paper thickness test printing pattern.
Paper thickness test pattern example:
12.Examine the printed pattern to determine which set of lines are aligned (showing the
smallest gap), and note the corresponding number.
13.After the pattern is printed, THICKNESS NUMBER appears. Press the Paper
Feed/Down d or Ink Cover Open/Up u button to select the number noted in step 12,
and then press the Enter button to save the selected value.
14.Press the Back/Left l button.
15.Select PAPER FEED ADJUST A, and then press the Menu/Right r button. Press the
Paper Feed/Down d or Ink Cover Open/Up u button to set the paper feed amount of
the printable area (A area in the illustration below), and then press the Enter button.
16.Press the Back/Left l button.
1
234
5
6
7
8
9
10
11 12 13
14
15
A