226 The Control Panel
Combination of buttons
This section describes the functions available when several
buttons are pressed at the same time.
9Paper check light
(red)
On:
No paper is loaded in the paper tray when
Sheet is selected as the paper source.
Roll paper is out when Roll Auto Cut On or
Roll Auto Cut Off is selected as the paper
source.
The selected paper source (Roll Auto Cut On
/Roll Auto Cut Off /Sheet ) does not
match the paper source in the printer driver.
The paper lever is in the released position.
The loaded paper is too thick for head
cleaning.
Flashing:
Paper is jammed.
Paper is not cut correctly after the print job
when Roll Auto Cut On is selected as the
paper source.
Paper is not loaded straight.
Paper is not detected.
Cut sheet is not ejected correctly.
Buttons Function
1. Power button
2. Pause button
If the printer is turned on while you are
pressing and holding the Pause button, the
printer enters the Maintenance Mode.
To Next Page
Loading...
