302 Maintenance and Transportation
8. Make sure REMOVE INK CRTG appears on the LCD, and then
remove all four ink cartridges from the left ink compartment.
9. Make sure INSTALL CNVRSION CRTG appears on the LCD, and
then insert three conversion cartridges in the slots on the left
ink compartment.
Note:
If REPLACE CNVRSION CRTG appears on the LCD, press the Pause
button. Remove the old conversion cartridge(s) from the left ink
compartment, and then insert the new conversion cartridge(s).
Finally, go to step 4 to start again.
To Next Page
Loading...
