1-21
Setting Up the Printer | 1-21
Connecting the Power Cord
1. Connect the power cord to the AC inlet on the back of the printer.
2. Route the power cord through one of the hooks on the left or right side
as shown.
3. Plug the power cord into a properly grounded electrical outlet.
Caution
Do not use an outlet that
is controlled by an
automatic timer or wall
switch. Otherwise, you
may accidentally shut off
the printer and cause
damage.
Printer Guide.book Page 21 Monday, April 22, 2002 3:02 PM
To Next Page
Loading...
