1-31
Setting Up the Printer | 1-31
Installing and Connecting to an Optional Interface Card
To connect the printer to an optional FireWire or Ethernet card, you first
need to install the card in your printer. You also need the appropriate cable.
Follow the steps below.
1. Turn off your computer and your printer.
2. IMPORTANT: Unplug the printer from its electrical outlet. Not doing
so may cause damage to the printer and the card.
3. Disconnect any interface cables from the printer.
4. Remove the two screws and take off the cover as shown:
5. Set the DIP switches and jumpers on the card, if necessary. See the
manual that came with the card for details.
Caution
You must unplug the
printer from the power
outlet, or you may
damage the printer and
the card.
Printer Guide.book Page 31 Monday, April 22, 2002 3:02 PM
To Next Page
Loading...
