Epson Stylus Pro 7890 - Page 49

Epson Stylus Pro 9890/9908/7890/7908 User’s Guide
Paper Handling
49
Taking up your prints
When the Auto Take-up Reel Unit is installed,
and the take-up reel core is loaded with paper to
take up in the desired direction, you can use the
unit to take up your prints.
A
Set the Auto switch to Forward or
Backward.
B
Send a print job to the printer.
The printer starts printing. The Auto
Take-up Reel Unit takes up the roll paper in
the direction you set in step 1.
Removing paper after take-up
After paper take-up, follow the steps below to
remove the take-up reel core.
A
Set the Auto switch to Off.
B
Cut the roll paper.
❏ Press the button to cut the roll
paper.
❏ If the roll paper cannot be cut with the
built-in cutter, use a scissors or cutter
sold at a store.
C
Turn the lever to unlock the movable unit,
and then slide it to the left so that the flange
knob clears the end of the take-up reel core.
While doing this, support the take-up reel
core with one hand to keep it from falling.
w
Warning:
Do not touch the Auto Take-up Reel Unit while
it is operating. Doing so may result in injury.
Note:
When printing by using the Roll Auto Cut On ,
set the Auto switch of the Auto Take-Up Reel Unit to
Off, otherwise the printer does not cut the paper. You
can set the Auto switch to Off during printing to cut
the paper automatically.