Epson Stylus Pro 7890 - Page 94

Epson Stylus Pro 9890/9908/7890/7908 User’s Guide
Problem Solver
94
Error messages related to the options
INK CARTRIDGE
NON-GENUINE CARTRIDGE!
QUALITY OF NON-GENUINE
INK MAY VARY
NON-GENUINE CARTRIDGE
MAY NOT PERFORM AT
OPTIMUM. CONTINUE?
DECLINE
ACCEPT
Non-genuine ink
cartridge is installed.
Select DECLINE to replace the ink cartridge with a
genuine Epson ink cartridge. Selecting ACCEPT
may void EPSON’s warranty.
See “About ink cartridges” on page 68
See “Replacing ink cartridges” on page 69
INK CARTRIDGE ERROR
PLEASE INSTALL THE CORRECT
CARTRIDGE
An ink cartridge that
cannot be used with
this printer is installed.
Remove the ink cartridge, and install an ink
cartridge that can be used with this printer.
See “About ink cartridges” on page 68
See “Replacing ink cartridges” on page 69
NOZZLE CLOG DETECTED
NOT ENOUGH INK
CONTINUE CLEANING?
YES (RECOMMENDED)
NO
There is not enough ink
to perform cleaning.
By clicking YES, the message to replace the ink
cartridge appears. Replace the ink cartridge with
a new one to continue cleaning.
See “Replacing Ink Cartridges” on page 66
NOZZLE CLOG DETECTED
NOT ENOUGH EMPTY SPACE
IN MAINT TANK
CONTINUE CLEANING?
YES (RECOMMENDED)
NO
There is not enough
space in the
maintenance tank to
perform cleaning.
By clicking YES, the message to replace the
maintenance tank appears. Replace the
maintenance tank with a new one to continue
cleaning.
See “Replacing the Maintenance Tank” on
page 71
CLOGGED NOZZLES DETECTED
CLEANING RECOMMENDED
Print head nozzles are
clogged.
Perform head cleaning to remove any clogs. This
message continues to be displayed until the
clogged nozzles have been cleared, but it is
removed when a check pattern is printed.
Printing is possible while the message is displayed.
See “Head cleaning” on page 78
Error messages Description What to do
TAKE-UP DISCONNECTED
SET AUTO TAKE-UP REEL SYSTEM
IN PRINTER AND RESTART THE
PRINTER
Auto Take-up Reel Unit is
not correctly installed in
the printer.
Turn the printer off, and then install the Auto
Take-up Reel Unit properly.
See “Using Auto Take-up Reel Unit (For
Epson Stylus Pro 9890/9908 only)” on page 46
TAKE-UP DISCONNECTED
AUTO TAKE-UP REEL UNIT IS
DISCONNECTED
DO YOU CONTINUE?
NO
YES
Auto Take-up Reel Unit is
not correctly installed in
the printer.
Select NO, and turn the printer off, and then
install the Auto Take-up Reel Unit properly. If
you select YES, the paper is ejected without
using the Auto Take-up Reel Unit.
See “Using Auto Take-up Reel Unit (For
Epson Stylus Pro 9890/9908 only)” on page 46
TAKE-UP ERROR
CHECK THE STATUS OF AUTO
TAKE-UP REEL UNIT AND
RESTART THE PRINTER
The roll paper is not set
to the Auto Take-up Reel
Unit properly.
Press the button to release the paper
presser, and then set the roll paper to the Auto
Take-up Reel Unit properly.
See “Using Auto Take-up Reel Unit (For
Epson Stylus Pro 9890/9908 only)” on page 46
Error messages Description What to do