Epson Stylus Pro 7890 - Page 95

Epson Stylus Pro 9890/9908/7890/7908 User’s Guide
Problem Solver
95
TAKE-UP ERROR
IS ANYTHING OBSTRUCTING
THE TAKE-UP REEL SENSOR
SYSTEM?
LOAD PAPER AGAIN
The Auto Take-up Reel
Unit does not wind the
paper.
Make sure there is no obstruction in the sensor
system. Press the button to release the
paper presser, and then set the paper
correctly in the Auto Take-up Reel Unit.
See “Using Auto Take-up Reel Unit (For
Epson Stylus Pro 9890/9908 only)” on page 46
SProofer DISCONNECTED
CONNECT SpectroProofer
TO THE PRINTER
AND RESTART THE PRINTER
The SpectroProofer is not
connected to the printer
properly.
Turn the printer off, and then connect the
SpectroProofer to the printer properly.
See the SpectroProofer Mounter 24"/44"
Setup Guide
ILS20EP DISCONNECTED
REFER TO THE MANUAL AND
CONNECT ILS20EP TO
SpectroProofer
RESTART THE PRINTER
The color measurement
device (ILS20EP) is not
connected properly.
Turn the printer off, and then connect the color
measurement device (ILS20EP) to the
SpectroProofer properly.
See the SpectroProofer Mounter 24"/44"
Setup Guide
Error messages Description What to do