118
Note:
If you replace the ink cartridge before a print job is finished, the
Stylus Scan automatically prints the remaining pages of the print
job once the ink cartridge is replaced.
c
Caution:
The
P
power light continues to flash while the Stylus Scan
performs the ink charging operation. Never turn off the
Stylus Scan while this light is flashing. Doing so can result
in incomplete charging of ink.
8. Close the front cover.
Replacing a black ink cartridge
To replace a black ink cartridge using the Stylus Scan’s control
panel, follow the steps below.
1. Make sure the Stylus Scan is on. The
P
power light should be
on, but not flashing.
2. Lower the output tray at the front of the EPSON Stylus Scan,
then open the front cover.
3. Hold down the
R
cleaning button for three seconds, then
release it. The print head moves to the cartridge replacement
position for the black ink cartridge. The
P
power light begins
flashing.
To Next Page
Loading...
