Unpacking and assembling the printer | 3
Unpacking and assembling the printer
Note: Unless otherwise indicated, the illustrations in this guide show the SureColor
®
P9500 Series, but the
instructions apply to all models.
Follow these steps to assemble your printer and its stand.
Before you begin, make sure you have enough space to set up and use the printer—at least
12 inches (305 mm) on all sides in addition to the dimensions of the printer and stand:
• 55.2 × 87 inches (1401 × 2211 mm) for the SureColor P7500 Series
• 75.2 × 87 inches (1909 × 2211 mm) for the SureColor P9500 Series
When choosing a place for the printer, choose a flat, stable location with adequate room for easy access and
ventilation, near an outlet that meets the power requirements of the printer. Avoid locations subject to
direct sunlight, excessive heat, moisture, or dust. Also avoid locations near potential sources of
electromagnetic interference, such as loudspeakers, cordless phones, TVs, or air conditioners.
The operating conditions of the printer should be between 50 and 95° F (10 to 35° C), with 20 to 80%
humidity (non-condensing). Also, avoid environmental conditions that may affect the paper.
WARNING: Four people are required to unpack and install the printer.
12 in. (305 mm)
12 in. (305 mm)
12 in. (305 mm)
12 in.
(305 mm)
To Next Page
Loading...
Need help?
General