Starting up and Shutting down the Printer
20
Starting up and Shutting down the Printer
Starting up the Printer
Click Pre-operation Check on the Client PC to start the printer.
In Pre-operation Check, the printer starts after the items that need to be checked manually have been displayed.
When Printer PC is connected to the printer, Printer PC starts automatically.
The Power switch on the back of the printer should normally be On (the light is on). If the Power switch is turned
off, check that the power cable is inserted in the AC inlet, and then turn on the Power switch (the light turns on).
A
Start the SL-D3000 Maintenance Utility.
You can use one of the following methods to display the pre-operation check screen.
On the Client PC, click Start - All Programs - EPSON SL-D3000 System Application - Maintenance
Utility.
Tip:
Normally, you do not need to operate the humidity control unit power switch.
See the following for more information on using the humidity control unit.
U “Adjusting the Humidity in the Roll Paper Feeder” on page 74
To Next Page
Loading...
Need help?
General