Replacing Paper
41
H
Slide the right Paper width guide to the left until it is flush with the edge of the paper.
I
If the paper type has changed, set the paper type on the Operation panel.
Each time you press the Paper type setting switch on the rear roll paper feeder, the paper type changes and
the light flashes to indicate the current paper type.
Note:
O Make sure that there is no gap between the Paper width guide and the edge of the paper. If there is a gap, the
print position may be misaligned, or a feeding error may occur.
O Do not push the Paper width guide against the paper too forcefully. The paper may be damaged, or it may
cause a paper jam.
Tip:
If you clear the cover open error by clicking OK on the Client PC, you cannot change the paper type. To change the
paper type, remove the paper from the Paper feed slot, reinsert it, and then try again.
To Next Page
Loading...
Need help?
General