2-10 Setup Rev. C
5. Push down the ink cartridge until it clicks firmly into place.
Note:
Do not use excessive force.
6. Close the printer cover (the INK LED goes off).
Note:
If the INK LED stays on, the ink cartridge is not installed properly. Check it again.
When the printer is used for the first time, it automatically performs the ink charging sequence for about 1
minute. During the ink charging sequence the POWER LED flashes. When the ink charging sequence is
finished, the POWER LED stops flashing, and the printer is ready for printing.
Do not turn off the printer or open the printer cover during the ink charging sequence (while the POWER
LED is flashing). If you do so, the printer must perform the ink charging sequence again from the start.
This will waste ink.
To Next Page
Loading...
Need help?
General