3-12 Using the Printer Rev. C
4. Printing is performed and paper is output.
Self test print example
5. The printer is ready to receive data as soon as it completes the self test. Normal printing is
now possible.
Note:
If this self test is not possible, try a self test by hand feeding paper ("Feeding paper by hand" on page 3-
13).
3.6.1.2 With the roll paper specification
Note:
You can check the operation of the autocutter with the self test when the roll paper holder is installed.
1. Check that the printer is turned off, the printer cover is closed, and the roll paper holder is
installed properly.
2. Install roll paper.
3. While pressing FEED, turn on the printer.
4. Printing is performed and the paper is cut.
Self test print example
5. The printer is ready to receive data as soon as it completes the self test. Normal printing is
now possible.
Note:
If this self test is not possible, try a self test by hand feeding paper ("Feeding paper by hand" on page 3-
13).
To Next Page
Loading...
Need help?
General