Rev. C Using the Printer 3-1
TM-C100 Technical Reference Guide
Chapter 3
Using the Printer
This chapter describes typical usage of the printer and troubleshooting.
3.1 How to Set, Replace, and Print on the Paper
3.1.1 With the auto sheet feeder (ASF) specification
3.1.1.1 How to set and replace the paper
Note:
Use paper that is flat, without curls, folds or wrinkles.
Do not print envelopes with a closure in the middle of the back.
During positioning performed by the printer before printing, the paper is moved toward the back of the
printer. If there is any obstruction behind the printer, it may impede normal positioning. Ensure that there
is sufficient space behind the printer.
1. Check that the printer is turned on. If it is turned off, turn it on.
2. Separate the sheets of paper, and line up the edges. Ensure that the paper lies flat.
3. With the print surface facing up, place the paper vertically in the auto sheet feeder aligned
against the left side.
4. Move the edge guide left or right to align the it with the edge of the paper.
edge guide
To Next Page
Loading...
Need help?
General