To Next Page

To Previous Page

3-10 Using the Printer Rev. C

Note:

When using OPOS-X, the option setting is set automatically. Change only the feed setting. (Use the

"SlpPaperBinNumber" properties.)

❏ Change the driver "Feed setting" to "ASF."

❏ Turn off the printer, and reconnect the cable of the ASF unit to the printer. Then turn on the

printer again.

❏ Check with "ASF Specification" on page A-7 that the size of the paper you are using is

appropriate for the product specification.

3.4.5 Hand fed printing is not possible

If after following "Feeding and printing paper by hand" on page 3-4 hand fed printing is not

possible, try the following measures again. (For information on how to set the driver, see the

driver manual.)

❏ Set paper feed in the driver to "Hand feed."

❏ If the roll paper holder is attached, remove it.

❏ After checking that the PAPER LED flashes after the print command was sent from the

driver, set the paper.

❏ Check with "Hand Fed Paper Specifications" on page A-9 that the size of the paper you are

using is appropriate for the product specification.

3.4.6 Eliminating excessive bottom margins (roll paper specification)

When using the APD, if you set the "Roll paper saving mode" in the driver, the printer cuts the

paper when printing finishes, irrespective of the paper size settings, so that the bottom margin is

not excessive. (For information on how to set the driver, see the driver manual.)

Note:

When using OPOS-X, any cut position can be programmed. Note that there is no "Roll paper saving

mode."

3.4.7 The paper is not cut (roll paper specification)

❏ You can use a self-test (see "Self Test Procedure" on page 3-11) to check the operation of the

printer. If the paper is not cut after self-testing, the printer may not be working properly.

Have it serviced.

❏ In the long print mode, the paper is not cut at a new page. Check the driver settings. (For

information on how to set the driver, see the driver manual.)

Note:

When using OPOS-X, any cut position can be programmed. Note that there is no "Long print mode."

Epson TM-C100 Technical Reference Guide

Other manuals for Epson TM-C100