Epson TM-H6000III Series - 2.4 Device Settings

Version 3.00 Feb. 2019
7
APPLICATION DEVELOPMENT GUIDE
POSPrinter (TM-H6000III)
2.4 Device Settings
The following explanation is about the settings for TM-H6000III.
2.4.1 Usable Device Specific Settings
For the TM-H6000III, the following device specific settings are settable by the
SetupPOS utility. For the detail, please refer to the Section 2 of “EPSON OPOS
ADK MANUAL APPLICATION DEVELOPMENT GUIDE POSPrinter (TM Series)”
Tab Settings
Disable panel buttons
Assume print complete when data output finishes
Homogenize Error Codes
*1
Ignore firmware version check
General
Output complete timeout [s]
Paper Type Paper
Paper Width [mm]: LineWidth [dot]: LineCharsList
Removal feed length [line]
Reverse feed removal
Slip
Blink LED with BeginInsertion
TMFlogo... Bitmap
NVRAM
Halftone: Method
Halftone: Brightness
Color Bitmap
Color: Primary
ERROR
OFFLINE
Log file name (full path name)
Status Log
Maximum file size [KB]
Multilingual font
*2
Default Value
Endorsement installation
Receipt Characters per Line
Receipt Line Spacing [dots]
Slip Characters per Line
Slip Line Spacing [dots]
Printing Properties
CharacterSet [CodePage Number]
*1
The settings can be changed when using a connection other than serial.
*2
Available only for the multilingual character models.