Version 3.00 Feb. 2019
APPLICATION DEVELOPMENT GUIDE
CheckScanner
15
check in the DocumentWidth and DocumentHeight properties before
executing the EndInsertion method.
Use the CHK_DI_ENDINSERTION_EXTEND command to enable the
setting.
Please refer to the CHK_DI_ENDINSERTION_EXTEND command
reference for details.
The settings with this command are effective only for check scanner
mode. Although during card scanner mode, a filtering area can be
set by executing this command, the settings are not reflected to card
reading directly. If these settings are set during card scanner mode,
the settings become effective after changing the mode to check
scanner mode, and only for reading checks.
Returned value One of the following is returned and stored in the ResultCode
property.
Value Meaning
OPOS_SUCCESS DirectIO succeeded.
OPOS_E_CLOSED The device is closed.
OPOS_E_NOTCLAIMED The device is not claimed.
OPOS_E_DISABLED The device is disabled.
OPOS_E_ILLEGAL Specifies command number without a
function and pre-scanning cannot be
executed.
OPOS_E_EXTENDED The paper is not inserted.
Other Refer to the ResultCode item.
Requirement Open, Claim & Enable
To Next Page
Loading...
