Epson TM-L90 series - Device Settings; Usable Device Specific Settings

Version 3.00 Feb. 2019
6
APPLICATION DEVELOPMENT GUIDE
POSPrinter (TM-L90)
The default settings are as shown in the following table.
Item Setting range
Output buffer length [byte] 1024
Output interval time [ms] 2500
2.4 Device Settings
The following explanation is about the settings for TM-L90.
2.4.1 Usable Device Specific Settings
For the TM-L90, the following device
specific settings are settable by the
SetupPOS utility. For the detail, please refer to the Section 2 of “EPSON OPOS
ADK MANUAL APPLICATION DEVELOPMENT GUIDE POSPrinter (TM Series)”.
Tab Settings
Disable panel buttons
Assume print complete when data output finishes
Homogenize Error Codes
*1
Ignore firmware version check
General
Output complete timeout
Bitmap TMFlogo...
Halftone: Method
Halftone: Brightness
Color Bitmap
Color: Primary
ERROR
OFFLINE
Log file name (include full path)
Status Log
Maximum file size [KB]
Paper Type Paper
Paper Width [mm]
Multilingual font
*2
Receipt paper layout type
Default Value
Peeler installation
Receipt Characters per Line
Receipt Line Spacing [dots]
Printing Properties
CharacterSet [CodePage Number]
*1
The settings can be changed when using a connection other than serial.
*2
Available only for the Multilingual character model.