Epson TM-L90 series - Diagnosing Failures

Version 3.00 Feb. 2019
11
APPLICATION DEVELOPMENT GUIDE
POSPrinter (TM-L90)
3.1.3 Width and Height Properties
The width and height properties are explained in the following.
Settings
Property
Default
Value
Maximum
value [dot]
Minimum
value [dot]
RecLineSpacing 30 127 24
*1
JrnLineSpacing X X X
SlpLineSpacing X X X
SlpLineHeight [dot] X
RecLineHeight [dot] 24,17
JrnLineHeight [dot] X
SlpLineWidth [dot] X
RecLineWidth [dot]
(When 80mm is set)
576
*5
JrnLineWidth [dot] X
RecSidewaysMaxLines 19
*3
RecSidewaysMaxChars
(When Font A is selected)
123
*4
RecSidewaysMaxChars
(When Font B is selected)
164
*4
RecLinesToPaperCut 6
*2
SlpSidewaysMaxLines X
SlpSidewaysMaxChars X
SlpMaxLines X
X: No settings
*1
In the case of a line thermal station, the Line Spacing setting is identical with the height
of the characters which means that it can be set at up to 17 when Font B is selected.
*2
It can be changed by the settings of the RecLineSpacing or the character height.
*3
It can be changed by the settings of the XxxLineSpacing or the XxxLineHeight.
The value differs accordance with the selected paper width.
*4
It can be changed by the settings of the font width, or the selected paper type.
*5
The value differs by the settings of the paper width or the layout of the label.