Version 3.00 Feb. 2019
29
APPLICATION DEVELOPMENT GUIDE
POSPrinter (TM-L90)
3.19 Label Receipt Usage
z Please specify the paper with the Memory Switch. To use the function related
to the label, the paper should be label paper or black mark paper.
z When using label receipt paper, the Escape Sequence ESC|#IF feeds the
receipt the specified length, or to the head of the next label.
3.20 Paper Cutting and Head Pulling Out Function
The
TM-L90
models have a function to continuously cut paper and pull out its
head. First, the printer feeds the paper to the cutting position when this function is
used. Next, it cuts the paper using the specified cutting rate. Finally, it pulls out
the head of the paper and the operation ends. Because the printer pulls out the
head of paper after cutting it, the blank on the paper at the upper side can be
reduced. This function can be used only if the receipt paper is set to the paper
setting. This function can be used by the PTR_DI_CUT_AND_FEED_TOF
command of DirectIO. Though the cutting rate can be specified using the pData
parameter of DirectIO, for the TM-L90, the cutting rate does not change according
to the value of pData, because the cutting rate depends on the installed position
of the auto cutter unit. However, when values other than 0 to 100 are specified for
pData, OPOS_E_ILLEGAL (OPOS_EX_BADPARAM + 2) is returned.
To Next Page
Loading...
Need help?
General
