Epson WF-2010 User Manual

Confidential
Troubleshooting Fatal Error Code List 17
WF-2540 / WF-2530 / WF-2520 / WF-2510 / WF-2010 series Revision B
Note *: Fault Detection Plate is a reflector attached on the CR Unit. (See Fig. 1-4)
Figure 1-4. Fault Detection Plate
PIS Board
device error
83H Reflector no reflection error
• Defective Fault Detection Plate
*
(detachment, peeled reflector)
• Sensor failure (contaminated Sensor, damaged FFC, PIS Board
installation failure)
88H Excessive Light error
• Abnormal sensor output (Sensor failure, PIS Board failure)
• Unexpected excessive amount of light such as too much diffused light
from outside is shed on the sensor because the housings are removed.
(When used outdoors or near the window where direct sunlight comes in)
89H Insufficient Light error
• Sensor failure (PIS Board installation failure, contaminated Sensor)
• Abnormal sensor output (Break of FFC during printer operation, PIS
Board failure)
• Unable to accurately detect where the fault detection plate is because too
much diffused light from outside is shed on the sensor. (When used
outdoors or near the window where direct sunlight comes in)
• Ink Cartridge failure (contaminated/damaged prism)
Table 1-3. Fatal Error List (Printer)
Error type
Error
code
Error name Possible cause
CR Unit
Fault Detection Plate

Epson WF-2010 Specifications

General

Print Technology	Inkjet
Print Resolution	5760 x 1440 dpi
Paper Capacity	100 sheets
Duplex Printing	Manual
Functions	Print
Print Speed (Color)	18 ppm
Connectivity	USB, Wi-Fi
Supported Paper Sizes	A4, A5, A6, B5