Epson WF-2010 - Page 51

WF-2540 / WF-2530 / WF-2520 / WF-2510 / WF-2010 series Revision B
Disassembly/Reassembly Routing FFCs/cables 51
Confidential
Head FFC (Routing on the Main Frame)
Align the Head FFC and CSIC FFC, and then route them through the FFC Holder as shown in the figure above.
Aligning Head FFC with CSIC FFC
Head FFC
CSIC FFC
Fold here inside FFC Holder
Stack the Head FFC over the CSIC
FFC to keep the Head FFC on top.
Head FFC/CSIC FFC
FFC Holder
Rear
FFC HolderMain Frame
Head FFC/CSIC FFC
Head FFC (Routing on the CR Unit)
 Route the CSIC FFC through the rib A and rib B, and then connect it to
the connectors of the CR Encoder and CR Contact Module.
 Route the Head FFC through the rib B and C, and then connect it to the
connector of the Printhead.
Double-sided tape
CSIC FFC
Connector of Printhead
Left side of CR Unit
Connector of CR Encoder
Rib B
Head FFC
CR Unit
Rib A
Rib C
Connector of CR
Contact Module