Epson WF-2660 - Wi-Fi Specifications; Ethernet Specifications

Supported Lines Standard analogue telephone lines, PBX (Private Branch Exchange) telephone
systems
Speed Up to 33.6 kbps
Resolution Monochrome
❏ Standard: 8 pel/mm × 3.85 line/mm (203 pel/in. × 98 line/in.)
❏ Fine: 8 pel/mm × 7.7 line/mm (203 pel/in. × 196 line/in.)
❏ Photo: 8 pel/mm × 7.7 line/mm (203 pel/in. × 196 line/in.)
Color
❏ Fine: 200 × 200 dpi
❏ Photo: 200 × 200 dpi
Page Memory Up to 100 pages (when received ITU-T No.1 chart in monochrome draft mode)
Redial
*
2 times (with 1 minute intervals)
Interface RJ-11 Phone Line, RJ-11 Telephone set connection
* The specications may dier by country or region.
Wi-Fi Specications
Standards IEEE802.11b/g/n
Frequency Range 2.4 GHz
Coordination Modes
Infrastructure, Ad hoc
*1
, Wi-Fi Direct
*2 *3
Wireless Securities
WEP (64/128bit), WPA2-PSK (AES)
*4
*1 Not supported for IEEE 802.11n.
*2 Not supported for IEEE 802.11b.
*3 Simple AP mode is compatible with a Wi-Fi connection (infrastructure) or an Ethernet connection.
*4 Complies with WPA2 standards with support for WPA/WPA2 Personal.
Ethernet Specications
Standards
IEEE802.3i (10BASE-T)
*1
IEEE802.3u (100BASE-TX)
IEEE802.3az (Energy
Ecient
Ethernet)
*2
Communication Mode Auto, 10Mbps Full duplex, 10Mbps Half duplex, 100Mbps
Full duplex, 100Mbps Half duplex
Connector RJ-45
*1 Use a category 5e or higher STP (Shielded twisted pair) cable to prevent risk of radio interference.
*2 The connected device should comply with IEEE802.3az standards.
User's Guide
Appendix
136