Epson WF-7720 Series - Page 28

5. Hold down the [WPS] button on the access point until the security light ashes.
If you do not know where the [WPS] button is, or there are no buttons on the access point, see the
documentation provided with your access point for details.
6. Tap Start Setup.
7. Close the screen.
e
screen automatically closes
aer
a
specic
length of time.
Note:
If connection fails, restart the access point, move it closer to the printer, and try again. If it still does not work, print a
network connection report and check the solution.
8. Close the network connection settings screen.
Related Information
& “Checking the Network Connection Status” on page 32
& “When You Cannot Make Network Settings” on page 241
Making Wi-Fi Settings by PIN Code Setup (WPS)
You can automatically connect to an access point by using a PIN code. You can use this method to set up if an
access point is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN code into the access point.
1. Tap
on the home screen.
2. Select Router.
3.
Tap Start Setup.
If the network connection is already set up, the connection details are displayed. Tap Change to Wi-Fi
connection. or Change Settings to change the settings.
4. Select Others > PIN Code Setup(WPS)
User's Guide
Network Settings
28