This section describes the
power-on sequences for this product. The preconditions are as
Normal power-on sequence
No error occurred at the last power-on, a
nd the power was turned off normally.
Initial ink charge has finished and every pack has sufficient ink.
No paper on the paper path.
The Printhead is capped by the cap of the Ink System.
CR Lock is engaged normally.
This indicates the Simple Sequence.
PG position is set to PG 1.
Option Cassette Unit is not installed.
The following explains how to use the
diagrams show the movement of each component as seen from the
1-1.If PG is other than 1, the APG Motor rotates to set PG to 1.*
2-1.Initializes the Printhead, and checks the fuse on the printer control
3-1.To identify the CR Unit position, the CR Motor rotates
counterclockwise and it confirms the CR Unit touches the Right Frame
slowly. It regards the point when the CR Unit touches the Right Frame
as the position specified steps away from the home position, and sets it
3-2.If it judges the CR Unit is in the home position, the PF Motor rotates
clockwise and resets the CR lock.
3-3.The PF Motor rotates counterclockwise and sets the CR lock.
The condition of the CR lock
The above shows the CR lock is set.
Right-pointing arrow: Moves to the 0-digit side
Left-pointing arrow: Moves to the 130-digit side
The figure shows the carriage is moving to the 0-digit side.
The rotation direction of
The above shows clockwise
The rotation direction of
The above shows clockwise
To Next Page
Loading...
