installed in a wrong place.
Problems related to print result or during printing
This section describes the
power-on sequences for this product. The preconditions are as
Normal power-on sequence
No error occurred at the last power-on, a
nd the power was turned off normally.
Initial ink charge has finished and every pack has sufficient ink.
No paper on the paper path.
The Printhead is capped by the cap of the Ink System.
The following explains how to use the
diagrams show the movement of each component as seen from the
The condition of the CR lock
The above shows the CR lock is set.
Right-pointing arrow: Moves to the 0-digit side
Left-pointing arrow: Moves to the 130-digit side
The figure shows the carriage is moving to the 0-digit side.
The rotation direction of
The above shows clockwise
The rotation direction of
The above shows clockwise
To Next Page
Loading...
