Safety PrecautionsSafety Precautions
All safety procedures described here shall be strictly adhered to by all parties servicing and maintaining thisAll safety procedures described here shall be strictly adhered to by all parties servicing and maintaining this
Strictly observe the following cautions. Failure to comply could result in serious bodily injury or loss of life.Strictly observe the following cautions. Failure to comply could result in serious bodily injury or loss of life.
s when servics when servic
performing maintenance.performing maintenance.
d in this manuald in this manual
, do not conne, do not conne
ct to a power sourct to a power sour
ce until instce until inst
ructed to do soructed to do so
Connecting to a power source causes high voltage in the Connecting to a power source causes high voltage in the
power supply unit and some electronic componentspower supply unit and some electronic components
even if the product power switch is off. If you need to perform the work with the even if the product power switch is off. If you need to perform the work with the
power cable connected to apower cable connected to a
power source, use extreme caution power source, use extreme caution
to avoid electrical shock.to avoid electrical shock.
Strictly observe the following cautions. Failure to comply may lead to personal injury or loss of life.Strictly observe the following cautions. Failure to comply may lead to personal injury or loss of life.
m ink in workinm ink in workin
any ink gets in your eyes, wash your eyes with clean water and consult a doctor immediately.any ink gets in your eyes, wash your eyes with clean water and consult a doctor immediately.
ch as air dusterch as air duster
g repair and mag repair and ma
ance, the useance, the use
of such products containing flammable gas is of such products containing flammable gas is
Strictly observe the following cautions. Failure to Strictly observe the following cautions. Failure to
comply may lead to personal injury or damage comply may lead to personal injury or damage
of the product.of the product.
rmed on this prrmed on this pr
t by persons unt by persons un
ar with basic safar with basic saf
ated on the seated on the se
the power source whose voltages is the power source whose voltages is
different from the rated voltage.different from the rated voltage.
s only with thos only with tho
introduction of second-source ICs or other non-approved components may damage the introduction of second-source ICs or other non-approved components may damage the
product and void anyproduct and void any
applicable Epson warranty.applicable Epson warranty.
In order to protIn order to prot
ors and circuors and circu
itry, use statitry, use stat
nt, such as anti-snt, such as anti-s
wrist straps, when accessing wrist straps, when accessing
internal components.internal components.
Do not tilt this prodDo not tilt this prod
ng the ink chargng the ink charg
times. Doing so may cause ink to leak from the product because it times. Doing so may cause ink to leak from the product because it
may take some time for the waste ink padsmay take some time for the waste ink pads
to completely absorb ink wasted due to completely absorb ink wasted due
to the ink charge.to the ink charge.
uch the ink ouch the ink o
k with bare hak with bare ha
nds. If ink conds. If ink co
, wash it off wit, wash it off wit
soap and water immediately. If you have soap and water immediately. If you have
a skin irritation, consult a a skin irritation, consult a
doctor immediately.doctor immediately.
To Next Page
Loading...
Need help?
General
