Epson WorkForce 633 User Manual

91
Replacing Ink
Cartridges
Ink Cartridge Handling Precautions
Never move the print head by hand.
Some ink is consumed from some cartridges
during the following operations: print head
cleaning and ink charging when an ink cartridge is
installed.
For maximum ink eciency, only remove an ink
cartridge when you are ready to replace it. Ink
cartridges with low ink status may not be used
when reinserted.
Epson recommends the use of genuine Epson ink
cartridges. Epson cannot guarantee the quality
or reliability of non-genuine ink. The use of
non-genuine ink may cause damage that is not
covered by Epson’s warranties, and under certain
circumstances, may cause erratic printer behavior.
Information about non-genuine ink levels may
not be displayed, and use of non-genuine ink is
recorded for possible use in service support.
Make sure you have a new ink cartridge before
you begin replacement. Once you start replacing
a cartridge, you must complete all the steps in one
session.
Leave the expended cartridge installed until you
have obtained a replacement. Otherwise the ink
remaining in the print head nozzles may dry out.
Do not open the ink cartridge package until you
are ready to install it in the printer. The cartridge is
vacuum packed to maintain its reliability.
Other products not manufactured by Epson may
cause damage that is not covered by Epson’s
warranties, and under certain circumstances, may
cause erratic printer behavior.
Do not turn o the printer during ink charging as
this will waste ink.
c
O
O
O
O
O
O
O
O
O

Epson WorkForce 633 Specifications

Printing Specifications

Maximum Print Resolution	5760 x 1440 optimized dpi
ISO Print Speed (Black)	15 ISO ppm
ISO Print Speed (Color)	7.2 ISO ppm
Two-Sided ISO Print Speed (Black)	7.5 ISO ppm
Two-Sided ISO Print Speed (Color)	4.5 ISO ppm
Minimum Ink Droplet Size	2 picoliters

Copy Specifications

Maximum Copy Size	8.5" x 14"
Copy Quantity	1 – 99
Copy Reduction and Enlargement	25 – 400%

Scan Specifications

Optical Resolution	2400 dpi
Hardware Resolution	2400 x 2400 dpi
Maximum Resolution	9600 x 9600 dpi interpolated

Fax Specifications

Modem Speed	33.6 Kbps
Fax Memory	Up to 180 pages
Speed Dials	60 (max.)

Connectivity

USB Connectivity	Hi-Speed USB 2.0
Wireless Connectivity	Wi-Fi (802.11 b/g/n)
Wired Ethernet	10/100 Mbps

Paper Handling

Maximum Paper Size	8.5" x 44"
Input Paper Capacity	250 sheets plain paper
Automatic Document Feeder	30 sheets

Operating Environment

Operating Temperature	50 ° to 95 °F (10 ° to 35 °C)
Storage Temperature	-4 ° to 104 °F (-20 ° to 40 °C)
Operating Humidity	20 – 80%

Power Specifications

Rated Voltage	100 – 120 VAC
Rated Frequency	50 – 60 Hz
Rated Current	0.6 Amp

Weight and Dimensions

Dimensions (Printing)	17.6" x 21.9" x 9.1"
Dimensions (Storage)	17.6" x 14.2" x 8.9"
Weight	16.8 lb