Epson WORKFORCE WORKFORCE 630 - Page 38

38 Wireless Network Setup
Setting Up With the Product Buttons
If you are using Mac OS X 10.6, or you don’t have a USB cable to set up the
product on your wireless network, follow these steps to set it up using the product
buttons:
1. Follow the instructions on the screen to start the product’s wireless Setup
Wizard.
2. When you see this screen, use the product’s buttons to select the name of your
wireless network, then press
OK . When you’re finished, click Next .
If your network name isn’t listed, try the following:
■ Make sure that your wireless router or access point is turned on and
working correctly. Press the y
Back button to return to the previous
screen, press
OK to select Setup Wizard , then repeat step 2.
■ If you still can’t find the network name in the list, your router or access
point is not broadcasting its network name. Press u or d to select
Other
SSIDs
, then press OK . Continue with the steps in “Entering Your SSID
Manually” on page 41.