QX50/QX200/QX2000; (SW Version 6.0.x) 30
QX50/QX200/QX2000 Manual I: Installation Guide
Use the MTU drop down list to select the maximum packet size on the Ethernet (in bytes).
Click Next to display the DNS Settings page.
DNS Settings
For DNS, the selection is set to Dynamically by Provider. When using a static IP address, fixed
values must be entered.
Fig.I- 23: DNS Settings page
The QX IP PBX will suggest the correct settings. If Dynamically by Provider is selected, the
DNS server settings will be set automatically whenever a connection to the Internet is estab-
lished.
If Fixed Nameserver Address is selected, manually enter the IP addresses provided by your
ISP for the name server and the alternative name server.
Clicking Next shows the summary page of the Internet Configuration Wizard.
Finishing the Internet Configuration Wizard
Fig.I- 24: Internet Configuration Wizard Summary page
Click the Finish button to complete the Internet Configuration Wizard. The QX IP PBX will then
stop internal functions and apply the changes made in the Wizard. After this is complete, the
QX IP PBX will display the Confirm Settings page requesting confirmation of the changes.
To Next Page
Loading...
Need help?
General
