1.9 Same barcode identification interval under
continuous scanning (D)
Incomplete delay is when the delay time ends when the
environment changes. Complete delay means that regardless of the
environment, it must be delayed for enough time to read the same
bar code again.(After the barcode gun scans the following 20102
bar code, the corresponding data code will enter the corresponding
setting for each scan (see Appendix C for the data code) After
scanning the data code, remember to scan the save code.）
Set the same barcode reading delay time (default 5, range 2-50,100 ms)
200ms 500ms
1s *5s
To Next Page
Loading...