Set the Code 128 maximum information length (the default value is 80)
Set the Code128 minimum information length (the default value is 1)
2.7 CODE-93 setting options
(1) The corresponding barcodes for opening and closing of
reading enabling are as follows.
* Open Close
(2) The barcodes corresponding to the checksum output check
characters are as follows.
Do not check *Verifies but does not output a verifier
Verify and output check characters
(3) CODE93 code reading code maximum and minimum
information length setting (D)
Set the Code 93 maximum information length (the default value is 80)
To Next Page
Loading...