9 / 62
1 • Safety Instructions
80110-201_V24169
2022-01
Operating errors and incorrect installation by persons without training
Operating errors and incorrect installation by persons without
training
Persons without training can operate or install the unit incorrectly.
Risk of injury or death for patients and medical staff! Risk of damage
to property.
The unit may only be used and installed by persons who have
been trained on how to use and install it properly according to this
User Manual.
Training may only be carried out by persons who are suitable on
the basis of their knowledge and practical experience.
In the event of uncertainties or if you have any questions, please
contact Erbe Elektromedizin. You will find the addresses in the ad-
dress list at the end of this User Manual.
Risks due to the environment
Interference with the unit from portable and mobile HF telecom-
munications units (e.g. mobile phones, WLAN units)
Electromagnetic waves emitted by portable and mobile HF telecom-
munications units may affect the unit.
The unit may fail or not perform properly.
When using portable and mobile HF telecommunications units, in-
cluding their accessories, there must be a distance of at least
30 cm between them and the unit and its cords.
Unsuitable temperature or level of humidity during operation
If you operate the unit at an unsuitable temperature or level of hu-
midity, it may sustain damage, fail, or not perform properly.
Operate the unit at a suitable temperature and level of humidity.
You will find the tolerances for temperature and humidity in the
Technical Data.
If other ambient conditions must be observed for operation of the
unit, you will also find them in the Technical Data.
Unsuitable temperature or humidity in transit or storage
If you transport or store the unit at an unsuitable temperature or level
of humidity, it may sustain damage and fail.
Transport and store the unit at a suitable temperature and level
of humidity. You will find the tolerances for temperature and hu-
midity in the Technical Data.
If other ambient conditions must be observed for transport and
storage of the unit, you will also find them in the Technical Data.
To Next Page
Loading...
Need help?
General
