Ericsson R380 - Page 30

30 Interface and Navigation
Display Indicators
When you successfully connect the R380 to your network
operator, the ‘Standby’ display is shown. On the display a
number of different indicators can be shown if activated.
The Standby display has the following sections:
• Status indicators in the upper and middle sections of the
display.
• Text and digit indicators in the middle section.
• Connection signal strength and battery power indicators
in the lower section.
Indicators
asterisk (*)
• Enter the character *.
• Enter a p (pause) character if held down.
Hash or Pound (3.)
• Enter the character #.
• Terminate the input of pin and security codes.
• Recall a phone number from the SIM card
phone book (enter the number of the memory
position and then press #).
• Ring volume set to 0. The ringing volume is turned
off.
• Silent mode. All audible signals are turned off.
• Text message received. A message has been
received.
• Divert calls. All incoming calls (unconditional) are
diverted to a defined number.
• Mute. The microphone is muted.
NETWORK
18-05-2000
12:00
!