Ericsson R380s - Page 168

168 Extras
To change the access security settings:
1.
Select
One-time passcodes
from the list displayed in the Extras/
System/Preferences/Messaging view. The One-time passcodes
view appears in the display.
If RSA SecurID or Safeword have previously been initialised,
then
Get serial number
will also be displayed.
Note: The initialisation information you receive from RSA Security
(RSA SecurID) and Secure Computing (Safeword) is confidential and
must be destroyed once you have entered the information into your
R380s.
To initialize or re-initialize the RSA SecurID:
•
Select
Initialise RSA SecurID
from the list displayed in the One-time
passcodes view.
If no previous initialisation has been performed, the Initialise RSA
SecurID view appears in the display. Select the
User ID:
and
Activation licence:
sections and enter your user identification and
the seed data in their respective sections, then tap . If any of
the entered values cannot be validated a warning message appears
stating which value was incorrect. Otherwise, an information view
appears informing you that “RSA SecurID has been successfully
initialised”. Select
OK
to return to the One-time passcodes view.
If initialisation has already been performed, a Re-Initialise
confirmation message appears stating that the “Current
initialisation data will be lost” and asking “Are you sure?”. Select
No
if you want to retain the previous initialisation and return to the
One-time passcodes view. Otherwise, select
Yes
. The Initialise
RSA SecurID view appears in the display. Change the
initialisation data as described above.
One-time passcodes
Initialise RSA SecurID
Initialise SafeWord
OK